• Scam Alert. Members are reminded to NOT send money to buy anything. Don't buy things remote and have it shipped - go get it yourself, pay in person, and take your equipment with you. Scammers have burned people on this forum. Urgency, secrecy, excuses, selling for friend, newish members, FUD, are RED FLAGS. A video conference call is not adequate assurance. Face to face interactions are required. Please report suspicions to the forum admins. Stay Safe - anyone can get scammed.

help making small hinges

PeterT said:
Good job. What retains the pin in place?
Click to expand...
Nothing yet. I need to order some retaining loctite. I have used regular blue thread lock before to retain shafts like this but only ever on my own stuff that I can repair if it fails. Figure this is the perfect excuse to buy the right loctite then I have it on hand for future projects. I had thought about other mechanical methods like peening but loctite is quick easy and I can't accidentally damage anything.

Can anyone recommend an easy way to finish the brass and remove tooling marks? I haven't worked much with brass. I was thinking maybe just really fine wet dry sand paper. I am fine with a dull finish or like a brushed look. Really I would just like to get rid of the tool marks from manual feeding. It is quite shiny so they show up depending how the light hits.
 
Needle files leave a very pleasant finish. Any of the softer rubber embedded finishing wheels in a dremel will make quick work, but leaves a little uneven finish (but still quite nice). some 600 wet and dry used wet with a sponge behind would work well. Options, Options!
 
Brass is pretty easy to finish, its quite forgiving. I have a whole collection of mini sanding blocks or sticks for lack of better word. I use 1/4" or 1/8 hardboard (MDF-type) scraps because I always have it laying around. Rather than wrapping (typically wet/dry) paper around an edge like a sanding block, I use a spray adhesive to bond it, then trimmed flush along the edge. The wood is very flat & sufficiently hard, it will do a better job of uniformly taking material down & avoids sloppy sanding technique. Same for chamfering edges. For the burnished look or blending out micro scratches to a uniform finish, I really like scuff pads that woodworkers use. You can get them down to 1000# & they don't load up nearly as much as sandpaper. Some people prefer steel wool. I have also mounted those to sticks where needed but aggressive double stick tape is about the only thing that keeps them mounted & thus you lose a side.

My eye is drawn to your radius. Not critiquing but it looks like a small step or at least compared to the adjoining mid section at this hinge angle. For stuff like this (intentional or not) I usually start out with a very fine scuff pad before sanding just to see what I'm looking at. The scuff pad shines everything uniformly matte & you can sometimes better see what you are dealing with. Machining marks could only be superficial & be blended out, or some may be deeper, or certain features need to be dealt with a file because machining can only go so far.

I haven't had much luck with clear protective finishes at least without dragging out specialty equipment. Some polishes contain waxes & that might be a better way to delay oxidization. Personally for brass I like hand finish & just let it take on its age with grace, at least in woodworking applications. Your mileage may vary.

1738251378077.png
 
You must log in or register to reply here.
Back
Top