• Scam Alert. Members are reminded to NOT send money to buy anything. Don't buy things remote and have it shipped - go get it yourself, pay in person, and take your equipment with you. Scammers have burned people on this forum. Urgency, secrecy, excuses, selling for friend, newish members, FUD, are RED FLAGS. A video conference call is not adequate assurance. Face to face interactions are required. Please report suspicions to the forum admins. Stay Safe - anyone can get scammed.

Better drill press vise?

@YYCHM I was looking for a 1/2-10 Acme tap so I could use Acme rod for the build instead of using threaded rod
 
Well I’m committed now.
Bought a length of 1” square stock to make the floating vise.
:)
 
I’ll probably buy it. I don’t have a follow rest so I can’t see how I could single point a piece ~10-12” long without intermediate support.
 
@David_R8
I’ll probably buy it. I don’t have a follow rest so I can’t see how I could single point a piece ~10-12” long without intermediate support.
Click to expand...

Its no problem David - just do light passes and a few spring passes at the end. You will probably be in the 5/8 or thicker rod anyway - I had no issues turning my cross feed that was 9/16"
 
Brent H said:
@David_R8

Its no problem David - just do light passes and a few spring passes at the end. You will probably be in the 5/8 or thicker rod anyway - I had no issues turning my cross feed that was 9/16"
Click to expand...

The design calls for 1/2” acme. What do you think about single pointing a 10” length of that?
 
David, you can make a very serviceable follow rest out of some 2X4.

Drill your 1/2" hole and bandsaw off half of it and mount it on centre such that when your saddle is positioned correctly, it is touching. My little lathe has T slots, but you will be aboe to work out something.

then only use your compound for all adjustments of your cutting tool...
 
Dabbler said:
David, you can make a very serviceable follow rest out of some 2X4.

Drill your 1/2" hole and bandsaw off half of it and mount it on centre such that when your saddle is positioned correctly, it is touching. My little lathe has T slots, but you will be aboe to work out something.

then only use your compound for all adjustments of your cutting tool...
Click to expand...

A 2x4 as in a piece of wood?
I think I can imagine this but I’ll have to do some mocking up.
 
yes a 2X4 piece of wood. For a larger lathe it might take a 2X10. Joe piecyzinski made a tiny one to single point thread a #5 40 thread on his big lathe. His custom follower features at 9:32 of his video:


even 3/4 plywood would work, providing it can be mounted. the cutting force on a single point acme tool is acouple of hundred pounds at most, and 50 pounds if being done in very light cuts.
 
David R8 - I think Fastener Force has Acme rod, don't know the cost but would be the quickest to get going if there are no shoulders required.
 
You must log in or register to reply here.
Back
Top