Jimbojones
Active Member
I've got about 5 sets (20) Shars set screws from BXA QCTP holders that I bought. These are 10mm OD but the drive is 3/16", not 5mm.
Swapped out all of my holder set screws to 5mm and willing to pass these on to a member would uses 3/16"-driven set screws.
Will give to first person to come pick them up. If you have any spare tooling like R8 5/8" collet or 5/8" end mill holder...or large diameter scrap aluminum rod e.g. 2"+ and can offer for a discount, that would be appreciated (but not necessary).
PM me if interested.
Swapped out all of my holder set screws to 5mm and willing to pass these on to a member would uses 3/16"-driven set screws.
Will give to first person to come pick them up. If you have any spare tooling like R8 5/8" collet or 5/8" end mill holder...or large diameter scrap aluminum rod e.g. 2"+ and can offer for a discount, that would be appreciated (but not necessary).
PM me if interested.