-
Scam Alert. Members are reminded to NOT send money to buy anything. Don't buy things remote and have it shipped - go get it yourself, pay in person, and take your equipment with you. Scammers have burned people on this forum. Urgency, secrecy, excuses, selling for friend, newish members, FUD, are RED FLAGS. A video conference call is not adequate assurance. Face to face interactions are required. Please report suspicions to the forum admins. Stay Safe - anyone can get scammed.
Planning to install my power feeder for my pdm30
- Thread starter Blouin55
- Start date
Blouin55
Michel
Pretty much easier with the "ins" i got.
I had to as well.
I eventually removed mine as I missed the hard stop more than I used the switch. The switch didn't stop on a dime either which was rather concerning.
Blouin55
Michel
Those were pre wired in the feeder, pretty easy to install in 10-15 minutes...they could be "stupid proof"...one more protection for the beginner i'm.
Blouin55
Michel
The most is to protect the feeder from itself, to avoid it hurt the edge of the mill.Ok, ok I'll install them...
Ok, ok I'll install them...
Don't fall victim to peer pressure ! Stay strong !
historicalarms
Ultra Member
I installed mine when I bought the power feed prob a dozen yrs ago now and have used it 3 or 4 times in that time....not used much but if i take the time to set the trip button then I must have thought it worthwhile at the time.