I guess it is, Rather than piling it up I would like to take it away though.
thanks, I will check that out. Also thanks for the heads up on the upgrading.
well I ordered one last night, let the learning begin. What do you use to control yours? I was thinking of going with a raspberry pi. Don't know much about them but a buddy local to me recommends them and has a couple.
It did come with the offline controller you can control the router, move to and set the home, origin position etc. and to send the contents of the files directly to the router without needing a PC connected to it via a USB cable. don't know if this was a waste but it was only about $10 more. on a side note, Amazon shipping has been very quick. Left Ontario on Sunday and already to Calgary and left the Amazon facility there.
Yes that would be no problem if I used smaller bits. It would have to be a small sign though since the bed is only 30 cm x 18 cm. As they come from the factory it is set up with an er11 collet with 1/8" size. I would need to buy a 1/4 collet to make use of some regular router bits. I know they do bed surfacing with a 1/4" shaft size not sure how much I could push it trying to take much of a cut with a 3/8 bit. Kinda like how you eat an elephant - just one bite at a time! It uses small bits but takes many bites.
