Making a Fixture for a Grinder (2023.03.04) --Instant upload

[a smile]

切割尺寸：310*260

19:30-------------------------------------------- ------------------------------------------
的

Three hours later ------

30 steel plate holes, tool machine -FP5/mh800, not familiar with programming, so manual punching,8.5mm. I will work hard to learn programming -----

The above two steel bars are purchased 25mm flat keys, which are also drilled in turn 10.2mm, with a spacing of 72.5mm*5

Hand drill chamfering is also fast

Starting grinder

Simply coarsely grind the opposite side

Fasten together with screws

t's 11 o 'clock at night. That's all for today. I'm a little tired
Good night!

 

[a smile]

Picking up where we left off last night:
13mm Hole spacing 13mm A total of 20.

View attachment 31641

The way you remove the screws

File the burr

Make a simple cutting table

Flat cut, rounded R3

Put the tooling on and try it out

Clamp the upper grinder for processing

The finished product, relatively perfect

Because it is not professional enough, it will take a long time. With the increase of experience, there will be faster technical improvement.

This is the processing tool of the afterrod in the chuck wrench designed by me. Maybe it will be sold in Canada in the future! Thanks for watching!