• Scam Alert. Members are reminded to NOT send money to buy anything. Don't buy things remote and have it shipped - go get it yourself, pay in person, and take your equipment with you. Scammers have burned people on this forum. Urgency, secrecy, excuses, selling for friend, newish members, FUD, are RED FLAGS. A video conference call is not adequate assurance. Face to face interactions are required. Please report suspicions to the forum admins. Stay Safe - anyone can get scammed.

Indexing/Dividing head manual question

Tomc938

Tomc938

Ultra Member
So I picked up a Vertex 5" (I assume since the mounting table is 5") dividing head today.

Looking online I can't seem to find a manual for it.

Does anyone have one or know where I could find one? I can't find a model number anywhere.
Screenshot 2023-11-04 at 5.13.41 PM.webp
 
Did you get the gauge blocks too? Congratulations..... I have the same one, bought it new, and it came with nothing of value in the box as far as a manual went. A couple YouTube videos, and there'll be very little mystery in the operation.
 
140mower said:
Apparently the fellow that had the dividing head also had a set of gauge blocks as well.....
Click to expand...

Ah, I see! That makes WAAAAY more sense. Silly me for thinking otherwise.

I'm my defense, I have a grinding indexer that has an integral sine bar system that uses sine gauge blocks. That's prolly what led me to conclude such a silly notion.

That's my story anyhow......
 
You must log in or register to reply here.
Back
Top