manualmachinist
Member
I dont know if this is the right website to post a bigger chuck but I will try. Seems to me there are a lot of good and reasonable people using this site.
Beautiful 12.375” OD self-centering 3 jaw Bison chuck.
Made in Poland.
D1-8 direct mount.
Hard master jaws with reversible hard top jaws. Youll notice the serial numbers of both the master and hard jaws match the SN on the chuck proper.
Superficial scratches and surface stains only.
I used this chuck occasionally on my D1-8 lathe I recently sold. I normally used a 10” OD 3JSC Bison chuck on this machine because it was easier on the machine (significantly lighter weight).
Rated for 2800 RPM, maximum.
$1000 plus HST. These are going for $3500-$4000 now.
Please private message me for my phone number. I am elderly and not good with email and I do not want to trouble too much those who help me post these ads.
Thank you for your understanding.
Beautiful 12.375” OD self-centering 3 jaw Bison chuck.
Made in Poland.
D1-8 direct mount.
Hard master jaws with reversible hard top jaws. Youll notice the serial numbers of both the master and hard jaws match the SN on the chuck proper.
Superficial scratches and surface stains only.
I used this chuck occasionally on my D1-8 lathe I recently sold. I normally used a 10” OD 3JSC Bison chuck on this machine because it was easier on the machine (significantly lighter weight).
Rated for 2800 RPM, maximum.
$1000 plus HST. These are going for $3500-$4000 now.
Please private message me for my phone number. I am elderly and not good with email and I do not want to trouble too much those who help me post these ads.
Thank you for your understanding.
