• Scam Alert. Members are reminded to NOT send money to buy anything. Don't buy things remote and have it shipped - go get it yourself, pay in person, and take your equipment with you. Scammers have burned people on this forum. Urgency, secrecy, excuses, selling for friend, newish members, FUD, are RED FLAGS. A video conference call is not adequate assurance. Face to face interactions are required. Please report suspicions to the forum admins. Stay Safe - anyone can get scammed.

Fly Cutter Success. Just wanted to share!

Jwest7788

Jwest7788

Joshua West
Administrator
Fly Cutter Success. Just wanted to share!

Looking good team. :)

2015-06-11 19.55.26.webp


I read a horror story of a user who immediately broke his mini mill gears with a flycutter, but all went well in my attempt. :)
 
Nice work JW. Next time drill the hole after so you don't get interrupted cuts. And if you give it a .005 depth of finishing cut, and about 800 rpm's for that size of piece, you will notice a vastly improved surface finish. You will get a 125 finish that way. Oh, I'm assuming you are using carbide.
 
You must log in or register to reply here.
Back
Top