Feeder for pdm30

[Blouin55]

Someone ever installed it on pdm30

 

[YYCHM]

Not a PDM30 but @David_R8 and I have installed that PF on RF30 clones.

 

[Blouin55]

Not a PDM30 but @David_R8 and I have installed that PF on RF30 clones.

How does it fit on?

 

[YYCHM]

How does it fit on?

Standby while I find our install threads.....

 

[YYCHM]

Here is my install.....

RF30 Basement Install

Nothing on my end but I ran across this on the CNCzone forum https://www.cnczone.com/forums/spindles-vfd/117782-huanyang-chinese-vfd-settings-manual.html

canadianhobbymetalworkers.com

 

[YYCHM]

@David_R8 's install starts here.....

DavidR8's shop shenanigans

That's it. I was able to bolt my PF directly to the boss on the table without said bracket.

canadianhobbymetalworkers.com

 

[Blouin55]

Here is my install.....

RF30 Basement Install

Nothing on my end but I ran across this on the CNCzone forum https://www.cnczone.com/forums/spindles-vfd/117782-huanyang-chinese-vfd-settings-manual.html

canadianhobbymetalworkers.com

I'll have to look at it...thanks!

 

[YYCHM]

I'll have to look at it...thanks!

The PF you're looking at is for Bridgeport clones. You will most likely have to make an adapter and deal with a discrepancy in the lead screw shaft dia.