• Scam Alert. Members are reminded to NOT send money to buy anything. Don't buy things remote and have it shipped - go get it yourself, pay in person, and take your equipment with you. Scammers have burned people on this forum. Urgency, secrecy, excuses, selling for friend, newish members, FUD, are RED FLAGS. A video conference call is not adequate assurance. Face to face interactions are required. Please report suspicions to the forum admins. Stay Safe - anyone can get scammed.

Calgary Member

Q

Quinn

New Member
Hey!

Relatively recent addition to the forum. It’s been a few months of reading and learning.

Located in Calgary. Purchased a old, and albeit quite worn out lathe from an contact. Have to cut your teeth somehow.

Mainly making lower precision custom bike parts, but over time will be improving performance of my old 1954 Logan 200 lathe to be a decent machine.

Always on the lookout for a reasonable sized mill. I would appreciate any leads. Ideally stepping away from a post / drill mill but money talks and all options considered!

Quinn
 
ha ha I'm a little slow this evening.

Pretty nice day out there today......I know this isn't going to last.
 
Motorized! It’s a parts bike comprised of 50’s, 60’S, 70’s and custom Harley Davidson

Currently it’s spacers, control knobs on the carb, bolts, etc. I have a list of items to do but also want to do a rear axle to tighten up the 50’s wheel a bit, etc. I’ll be needing some mild mill help for that just to make some flats.
 
You must log in or register to reply here.
Back
Top