Brand new x-axis power feed

[thriller007]

This was a late night impulse buy that will not work with my machine without a lot of modifications so thought I would offer it up on here. It is best for something with a 5/8 shaft. I paid $182 for it and could send it back but I figured if someone on here wants it I have a guy who is coming to Calgary tomorrow morning and I could send it up with him.

 

[thriller007]

It would be better on a Bridgeport style knee mill.

 

[DPittman]

Thats cheap. The beat deal I could find for a similar unit for my mill was $245

 

[thriller007]

Thats cheap. The beat deal I could find for a similar unit for my mill was $245

Yep that’s why I thought I would pass it along to someone on here

 

[Johnwa]

Do you still have this? Do you have a measured drawing of it?
I measured my shaft as 17mm which is a bit bigger than ⅝”.

thanks
John

 

[thriller007]

Yes I still have this. I had to go look in the manual to see what it had for measurements and it was just what you see below. 17 mm is .669 - .625 is .044 that would have to be bored out of the gear in total if you decided to use it.

 

[thriller007]

not going to work for John so it is still available.

 

[Tom Kitta]

Price online is still 182 its shipped from BC. I wonder how good these are. seller goes by different names and has so-so reputation.

 

[Kelly McLaughlin]

Hi Thriller! I'd like to buy it from you, I'm heading out the door on a two week vacation. I PM you last night but got no reply so If you can wait till I get back we'll sort it out then. Dabbler will vouch for me : )

 

[Dabbler]

Kelly is a great guy. Dependable.

 

[thriller007]

I don’t doubt it. He tried to get in touch with me again but then It just happened to be the only time I was without service because I was in the backcountry. I am sure we will get to make contact soon.

 

[thriller007]

In Kellys hands now.

 

[Kelly McLaughlin]

It sure is! It looks exactly like the two I put on the big mill I sold when down sizing, I have a project to come that is a 1914 horizontal mill a Bristol Number 0 , mid size or small floor model mill. I should have it here in a month or so so I'll post pics to the project section then. Thanks everyone!