Arboga drill

[millwrightgoose]

Looking to sell my arboga arm drill, currently under power and can be tested in my shop. Morse 3 taper, purchased about 8 months ago and never used so time to make space. Huge 2” thick plate bolted to the table but I have no idea the condition of the factory table. Looking for 2250$ to get my money back out of it. If this price is out of line please let me know. Machine is located west of Ottawa by about 45 minutes
Cheers

 

[Ironman]

That's a great little drill. And your price is right. I wish I could justify buying it, but my Nider 64 (which cost 1000) would be hurt and peed off.

 

[Martin w]

I agree, that is a great drill. Also, a nice set of Hillman rollers!

 

[buckbrush]

For that price I would need a look under that 2” plate.

 

[millwrightgoose]

For that price I would need a look under that 2” plate.

I can pull it for you, even offer a discount if I keep the plate. Maybe I should pull it anyway

 

[Susquatch]

Guys - Just a reminder that comments (especially not negative) are not allowed on classified posts. Only clarifying questions.

 

[buckbrush]

Sorry, I guess I should have been more direct. It might be that the plate is on to cover a damaged table and reinforce it. It would be a good idea to remove the plate to find out. This model of Arborga drill is much larger than the models I have seen around here, and they seem to sell for around the price that is being asked for this much bigger model.

 

[Dan Dubeau]

Nice look drill. Would love to have a shop big enough for a radial at some point. GLWS

 

[millwrightgoose]

Here’s a photo of the table. Dare I say it’s fair?