• Scam Alert. Members are reminded to NOT send money to buy anything. Don't buy things remote and have it shipped - go get it yourself, pay in person, and take your equipment with you. Scammers have burned people on this forum. Urgency, secrecy, excuses, selling for friend, newish members, FUD, are RED FLAGS. A video conference call is not adequate assurance. Face to face interactions are required. Please report suspicions to the forum admins. Stay Safe - anyone can get scammed.

Anyone have a metal brake I can use?

Jwest7788

Jwest7788

Joshua West
Administrator
I need to make some 90 degree bends in ~3' lengths of ~3/16" steel, maybe less thick, but in that area.

Hoping someone has a brake long enough!

I'll come prepared with steel all laid out, need to make about 12 bends total.

Cell: (40)3 617 3364
Text me or call after 5:00!

Alternatively, shoot me your number and I'll call you!
 
A press brake will easily do 3/16, but you are talking about a very expensive brake to handle that material properly. An apron brake might do it but it would also have to be huge. I would say a press brake is the right tool for the job.
 

Attachments

  • 1-29-2018 0000.webp
    1-29-2018 0000.webp
    11.2 KB · Views: 5
Hmm, I'll get an actual measurement tonight, 3/16" is probably too high an estimate, but i'll reply back here with the actual number tonight.

JW
 
Jwest7788 said:
Hmm, I'll get an actual measurement tonight, 3/16" is probably too high an estimate, but i'll reply back here with the actual number tonight.

JW
Click to expand...


Yeah, My estimate was way off. The actual thickness needs to be slightly thicker than ~1.75mm (13 or 14 gauge) X ~3'


Gauge in mm
13 0.0897 2.278
14 0.0747 1.897


pressbrake.webp
 
Old thread, I know...

What are guys using to make simple bends in small stock?

I know a vise and a BFH works but that’s a little crude
 
Chicken lights said:
Old thread, I know...

What are guys using to make simple bends in small stock?

I know a vise and a BFH works but that’s a little crude
Click to expand...
Not sure what you mean by small stock, but sheet metal thinner than about 20 gauge I have a small brake that works okay (very small) . If it's iron and structural steel sort of stuff I use heat and vice.
 
It's not very portable and not for rent. It's a shop built press brake and used in a 20 ton press. It's 6 inches long and would probably do 1/8 inch material at 6 inch width. More at lesser width. It bends to 90 degrees. It was made to screw directly on to the ram of that press so not usable on other presses. If your needing a few bends for a project I'd try to help out? To be honest it came with the press and I've never used it.
 
You must log in or register to reply here.
Back
Top